Your source for test equipment made to your specific requirements from testers to specialty electronics to software in order to analyze your Bosch Rexroth proportional or Bosch Rexroth servo valve or system! Engineering Technology Services is proud to offer our customers our latest line of Green Technology, state of art testing & analyzing equipment.
For Testing Proportional & Servo Valves
This joint venture between E.T.S. & Dietz Automation is proof of our continued drive to offer you the very latest technology available anywhere in the world today!
Our Business Partner ~
Dr. Mikhail V. SHASHKOV
Master degree from the University of Nizhny-Novgorod, faculty for numerical mathematics and PhD in mathematics (differential equations). For several years he worked as a scientist at the institute for applied mathematics and cybernetics in Nizhny-Novgorod. Over 30 publications. Mikhail Shashkov is the main developer of the test equipment ValveExpert & Owner of DIETZ automation GmbH.
Latest Pump & Motor Test Stand Technology
Engineering Technology Services (E.T.S.) is committed to providing our customers with the most reliable remanufactured Bosch Rexroth pumps and motors possible.
- Two test stands that have boosted and filtered suctions from 0-265 GPM for open and closed loop units
- Manifolds using Logic Technology are capable of 6500 psi for closed loop pumps and open loop pumps
- Dynamic testing for motors
- All computerized testing to ensure true efficiencies
- Test reports available upon request
- E.T.S. uses the latest technology in adjustable frequency A.C. drives
Latest Valves Test Stand Technology
- Repair center was built using clean room technology
- Three state-of-the-art valve test stands constructed from extruded aluminum and stainless steel to reduce any form of contamination
- Capable of testing standard flow, pressure and directional control valves, as well as proportional and servo valves
- Automatic or manual test can be conducted using Lab View, and our universal control board makes it simple to select either automatic or manual test, as well as selecting pressure, voltage, control signal, etc.
- Capable of producing hysteresis curves for differential pressure, flow, leakage, spool position and plotting frequency response curves